- 1 How do you remove an old P-trap?
- 2 How do you remove a stuck metal faucet nut?
- 3 Can you replace metal P-trap with PVC?
- 4 Why does my P-trap smell?
- 5 Does P-trap need washer?
- 6 Why does P-trap leak?
- 7 What is the difference between a J bend and a P-trap?
- 8 How do you remove U-bend?
- 9 Can I use plastic P trap to metal?
- 10 Can I connect plastic P trap to metal?
- 11 Are metal P traps better than plastic?
How do you remove an old P-trap?
Unscrew the nuts holding a plastic P-trap by hand, gripping the trap firmly with one hand and rotating each nut counterclockwise. You must unscrew two nuts to remove the trap. One holds the trap to the tailpiece, the small length of pipe extending down from the sink, and the other holds the trap to the drain line.
How do you remove a stuck metal faucet nut?
Share All sharing options for: Loosening a Stuck Nut
- Tighten the nut. Moving the nut in any direction is progress.
- Tap with a hammer. Jarring the nut can break its bond to the bolt.
- Apply heat. Metal expands slightly when hot, which may be enough to crack the nut free.
- Soak the nut.
Can you replace metal P-trap with PVC?
Purchase a PVC P-trap, pipe and fittings to replace the metal ones. PVC drain pipe comes in two different diameters: 1 1/4 inches and 1 1/2 inches. Make sure to buy material that’s the same diameter as the metal pipes you just removed.
Why does my P-trap smell?
A P-trap is the curved portion of pipe under the sink. It’s supposed to create a seal by holding water, which prevents sewer gases from getting into the bathroom. If the P-trap isn’t working properly, sewer gasses can make their way into the bathroom and cause your sink to stink.
Does P-trap need washer?
You need a washer where the tail piece goes into the trap. No washer where the trap connects to the wall pipe. It’s a 1 1/2″ trap.
Why does P-trap leak?
When a P-trap leak occurs, it’s usually because the nuts aren’t tight enough, the pipes are misaligned or a P-trap washer isn’t seated correctly.
What is the difference between a J bend and a P-trap?
The J-bend beneath the sink is also referred to as the P-trap, the U-bend and sometimes even just the drain trap. In some cases, however, hand-tightening may not seat the washer correctly, particularly if your drain pipes are metal, so slip-joint pliers will often come in handy.
How do you remove U-bend?
Look under your sink and find the U-bend, it’s the first bend in the pipe immediately below the plughole. Put your bucket/dish under the U-bend and carefully unscrew the section of pipe. The U-bend has two sets of threads, one at either end. As you loosen them any backed up water will drain out, so take your time.
Can I use plastic P trap to metal?
P-traps can be plastic or metal. It isn’t an issue if the two components are made of dissimilar materials, because the flange that seals the trap opening is always plastic. So don’t be intimidated.
Can I connect plastic P trap to metal?
You cannot glue PVC to metal and get a good seal. The pipe is probably only a few inches long and threaded into the verticle line at a fitting.
Are metal P traps better than plastic?
If you’re looking for durability in a P trap that needs replacing, you will find that one made of plastic is generally more durable than a metal one. The exception may be a metal P trap made of heavy gauge brass.