Often asked: How To Remove Metal Fence Post Spike?

How do you remove a metal fence pole?

To remove a metal fence post set in dirt, some strong muscles, a shovel, and patience will do the job. To remove a metal fence post set in concrete, you can pry it out with a car jack, tractor, or lever made from lumber. If it’s set in continuous concrete, you may need some heavier machinery, like a jackhammer.

Can you reuse fence post spikes?

PS-01: Post spikes can be used to fix fences. The surface of the post spike is plated with zinc, which means that it can prevent itself and the base of post free of the damage from moisture environment. So it has a long life to reuse and provide cost effectiveness to you in the long run.

How do you get rid of ground spikes?

The Process:

  1. Thoroughly wet the dirt, or wait until you have had some heavy rains to soften it.
  2. Dig down with the trowel to expose a couple of inches of the spike.
  3. Bash the tip of the spike sideways with a sledge hammer or large mallet.
  4. Tug the spike out of the ground.
  5. If it resists, bash it some more.

Are fence post spikes strong?

A post-mix is stronger and lasts many more years when compared to a spike. If you are erecting a fence for a short period then the fence spike will be the better option because it’s easy to remove.

You might be interested:  Readers ask: How To Remove Rust From Metal Cleaning Vinegar?

Can you use old fence posts?

If the fence posts of your existing fence are in good shape but the fence itself isn’t, you can replace the fence panels and attach them to the existing posts. To check whether your existing fence posts are in good enough shape to reuse, poke the wood with the tip of screwdriver.

How do you remove a fence post from a Metpost?

you’ll need a scaffolding pole and a piece of chain fastened around the bit of the metpost you can see. If you cant see much of it then you’ll have to drill through the sides and attach shackles. Use the scaffold pole as a lever to pull out the metpost, bracing against a piece of timber on the floor.

How do you remove metal fence posts in concrete?

Start by using your shovel to dig around the steel fence posts and the concrete. This will make it easier for you to remove them later. Dig all the way down to the bottom of the concrete. Wear gloves for digging and then try moving the steel fence posts backward and forward to loosen them a little.

Can you reuse fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

Leave a Reply

Your email address will not be published. Required fields are marked *