- 1 How do you remove a rusted toilet flange screw?
- 2 What happens if toilet flange is broken?
- 3 Can I reuse toilet flange?
- 4 How much does it cost to replace a cast iron toilet flange?
- 5 Can you drill a cast iron toilet flange?
- 6 Is the toilet flange glued to the pipe?
- 7 Should toilet flange sit on top of tile?
- 8 Why do toilet anchor bolts rust?
- 9 Does a toilet flange need to be screwed to the floor?
- 10 Can you replace toilet bolts without removing toilet?
How do you remove a rusted toilet flange screw?
The best ways to remove a rusted toilet flange bolt are:
- Spray the rusted bolt with penetrating oil.
- Cut through the bolt using a Dremel equipped with a metal cutting wheel.
- Use an oscillating cutter with a metal cutting blade to slice through the bolt.
- Cut the bolt using an angle grinder.
What happens if toilet flange is broken?
A toilet flange has a metal or plastic ring that holds the toilet to the floor, and when the ring breaks, it can render the toilet unusable. If the toilet rocks because the flange is no longer holding it securely, the wax ring seal can break, water can begin to seep out and problems quickly multiply.
Can I reuse toilet flange?
Remove the old hold-down bolts – don’t reuse them. You may want to clean and paint the wall behind the toilet. Also, inspect the toilet flange for sound condition. It should stick up about 1/2″ from the finished bathroom floor.
How much does it cost to replace a cast iron toilet flange?
On the other hand, hiring a plumber to replace the flange will ensure that the job is done right by a licensed, experienced professional. The cost for a plumber to replace the toilet flange varies by region and service provider, but the average price range is approximately $130 to $310.
Can you drill a cast iron toilet flange?
Cast Iron Flanges A broken cast iron flange can be a pain to fix properly. First, try and drill a series of holes in the lead that is in between the flange and the cast iron pipe. Once you have drilled the lead enough, cold chisel, fight, pick, and pry the lead and oakum out and pull the flange.
Is the toilet flange glued to the pipe?
This toilet flange is designed to glue on the inside of the pipe or expand inside the pipe. If it isn’t, then you will have to cut away the old flange. If the plastic pipe has a 3-inch inside diameter, you’ll have to remove the old flange from the outside of the pipe.
Should toilet flange sit on top of tile?
The toilet flange needs to be on top of the finished floor. Meaning the bottom edge of the flange needs to be on the same plane as the toilet. So if your toilet sits on the tile, the flange needs to be on top of the tile too. The spacing of the toilet exit “horn” and sealing surface is designed for this height.
Why do toilet anchor bolts rust?
Moisture around the base of the toilet can corrode the anchor bolts. This moisture may be the result of water escaping from the toilet because of an imperfect seal or, in basements near sea level, it may come from condensation or poor drainage.
Does a toilet flange need to be screwed to the floor?
The flange should be fastened to the floor. Dry fit the toilet to make sure it doesn’t rock. If it does rock, use shims to prevent rocking – just tightening the bolts probably will not stop the rocking but will risk cracking the toilet or breaking the flange.
Can you replace toilet bolts without removing toilet?
You can’t replace a closet bolt without removing the bowl. Pull the bowl, and next time pick up brass bolts.