Question: How To Remove Metal Fence Posts?

What is the easiest way to remove metal fence posts?

To remove a metal fence post set in dirt, some strong muscles, a shovel, and patience will do the job. To remove a metal fence post set in concrete, you can pry it out with a car jack, tractor, or lever made from lumber. If it’s set in continuous concrete, you may need some heavier machinery, like a jackhammer.

How do you get a metal pole out of the ground?

Common Pole Removal Tools and Methods A generic piece of equipment like a car jack with significant leverage is usually the go-to option besides a post puller but lacks grip and control. You can lift poles out of the ground by placing the jack underneath the pole.

How do you remove a metal fence post from a concrete slab?

Start by using your shovel to dig around the steel fence posts and the concrete. This will make it easier for you to remove them later. Dig all the way down to the bottom of the concrete. Wear gloves for digging and then try moving the steel fence posts backward and forward to loosen them a little.

Can you reuse fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

You might be interested:  FAQ: How To Remove Paint From A Metal Miniature?

How do you get a post out of the ground?

Position a garden hose next to the T-post and allow water to flow freely into the post hole. Continue rocking the T-post back and forth with water flowing into the post hole. Pull up on the post periodically until the T portion of the post breaks free from the ground.

How do you remove metal from concrete?

If this doesn’t work, your only recourse short of breaking up the pad is to cut the posts flush with an angle grinder or reciprocating saw that has a metal-cutting blade attached. You may be able to hide the cut posts by grinding the ends to get them below the concrete surface and covering each one with concrete patch.

Leave a Reply

Your email address will not be published. Required fields are marked *