Quick Answer: How To Remove Old Metal P-trap Tail Peice From Wall?

How do you remove an old metal P-trap?

Grab the nut holding the end of the P-trap to the house drain, using a pipe wrench. Hold the P-trap pipe steady with a second pipe wrench. Turn the nut counterclockwise until it turns by hand. Pull the nut away from the house drain.

How do you remove a tailpiece?

Loosen the nut connecting the tailpiece — the straight section of pipe that connects the sink to the P-trap — to the drain body on the underside of the sink. Unscrew the tailpiece using a wrench or pliers. Pull down on the pipe to break it free.

Which way do you twist a P-trap?

Unscrew the nuts holding a plastic P-trap by hand, gripping the trap firmly with one hand and rotating each nut counterclockwise. You must unscrew two nuts to remove the trap.

Why does my P-trap smell?

A P-trap is the curved portion of pipe under the sink. It’s supposed to create a seal by holding water, which prevents sewer gases from getting into the bathroom. If the P-trap isn’t working properly, sewer gasses can make their way into the bathroom and cause your sink to stink.

How do you remove cleanout plug?

If the plug breaks loose, you’re home free. Start cleanout plug removal by applying gentle heat to the cleanout plug and fitting to soften the old pipe dope (Photo 1). If that doesn’t work, wait for the pipe to cool, apply rust penetrant, and then apply double hammer blows around the fitting (Photo 2).

You might be interested:  Often asked: How To Remove Electorpencil From Metal?

Why does P-trap leak?

When a P-trap leak occurs, it’s usually because the nuts aren’t tight enough, the pipes are misaligned or a P-trap washer isn’t seated correctly.

Can you replace metal P-trap with PVC?

Purchase a PVC P-trap, pipe and fittings to replace the metal ones. PVC drain pipe comes in two different diameters: 1 1/4 inches and 1 1/2 inches. Make sure to buy material that’s the same diameter as the metal pipes you just removed.

How do you clear a clogged pipe?

If you find yourself with a clogged drain line, hot water, vinegar, and baking soda can serve as an inexpensive way to unclog it. Pour the hot water down the drain first, then baking soda, then vinegar, followed by more hot water after you’ve let the mixture sit in the drain for 10-15 minutes.

Does a sink tailpiece need a washer?

If it is a kitchen sink you first connection at the basket strainer requires a special washer that is flat on the top and fits into the tailpiece.

Can I cut sink tailpiece?

Tailpieces often can be cut if you can’t find one the length you want. Essentially, it has to be long enough to fit into the trap far enough so it is both stable and you can tighten up the compression fitting there doesn’t have to be much of any sticking out further.

Leave a Reply

Your email address will not be published. Required fields are marked *