Readers ask: How Do You Remove Metal Clips From Skateboard Bearings?

Can you remove bearing seals?

Very gently remove the rubber seals by prising out the seal from the inner lip. You can use a penknife or small screwdriver but do not push it too far into the bearing or you may damage the retainer (cage). Once satisfied that the bearing is completely grease-free, use a lint-free cloth to dry the bearing.

Can I use WD40 on skateboard bearings?

Can you use WD40 on skateboard bearings? NO. WD40 is a degreaser – not a grease!! The object of cleaning your bearings is to remove all the grease, clean the bearings, then add grase back in.

What household items can you use to lube bearings?

If you don’t have a skate bearing lubricant at home, you can use either sewing machine oil or oil for electronic gadgets. Don’t use motor oil, WD-40, petroleum jelly, or cooking oil because they’re unsuitable for bearings. Also, be careful of the amount of oil you’ll be putting on each bearing.

Do sealed bearings need grease?

FOR STARTERS, note that most sealed bearings come pre-greased from the factory with a 25%-35% grease fill. This is all the grease the bearings will ever need, because the relubrication interval (explained below) is longer than the expected life of the bearing.

Can you lubricate a sealed bearing?

If you are using a shielded bearing or an orange seal bearing you can apply the oil to the bearing with the seals/shields intact. If you are using a contact sealed bearing or grease you will need to remove the seals/shields to apply the lubrication.

You might be interested:  Quick Answer: How To Remove Flaking Contact Paper From Metal?

Should I take the shields off my bearings?

Be careful not to damage your bearing shield. If you can, remove one shield. If no shields are removable, then it is probably best to just get new bearings. After the shields are off, on one side you should see a plastic looking thing over the steel balls. Just clean the bearings with this on.

Can you fix rusted bearings?

Pack some basic toothpaste in your bearings and give them a good long spin. After the toothpaste is all brown and nasty rinse it out with water and blowdry them.

Leave a Reply

Your email address will not be published. Required fields are marked *